When it arrives to constructing a split keyboard, you have a good deal of options when it arrives to the cable. A lot of will use a conventional 3.5 mm TRRS cable, and some others could use a little something more esoteric like RJ-45 to run concerning the halves. This only functions if you are making use of two controllers if you only want a single controller, you have to pass the matrix from a person facet to the other, which generally needs extra than the 4 wires available by the aforementioned options. Although rummaging close to, [Joe Scotto] found a VGA cable and imagined, why not use that?
This pretty Barbie-themed peripheral is a split variation of an earlier board he developed named the ScottoFly, which is a monoblock split with a void in the middle. As with that 1, this is hand-wired applying thicc brass insulated with heat-shrink, takes advantage of a strong 3D-printed plate, and a printed scenario. And like a madman, [Joe] coiled the cable.
Sad to say, this proved to be problematic in the wire breakage perception, or so he thought. The actual dilemma turned out to be that the middle row of pins on a VGA connector all act like floor, so they can’t be utilized to pass rows and columns. However, there have been nonetheless sufficient viable pins to send the 4×5 matrix across. Be absolutely sure to look at out the create movie soon after the crack.
Via KBD #103